PureFlow AirDog FP-100 Manual de instalación descargar pdf (Pagina 11)

Installation Manual Section 5

PUREFLOW® DIESEL SYSTEM

AirDog™

Fuel Suction Line

Cont’d

Figure 5: Fuel tank

To release quick-connect fitting from fuel tank suction tube, firmly push fitting toward

the component being serviced while firmly holding the plastic retainer ring into the

fitting. While the plastic ring is depressed, pull the fitting assembly from the suction

tube. Use care to press the retainer ring squarely into the fitting body. It may be

difficult to disconnect the fitting if the retainer is cocked during removal.

Note: After removing the factory line check to make sure that the blue plastic retainer

was removed with the line. If the blue retainer remained attached to the tank tube, it

MUST be removed before the AirDog™ fuel line will connect to the tank tube.

5 - 4 Connect 'New Fuel Suction Line' swivel end to #8 male flare fitting at AirDog™

port marked 'FUEL IN'.

FUEL IN

Figure 6: Connecting the AirDog™ to the suction line of the tank

Quick connect

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

Sin comentarios

PureFlow AirDog FP-100 Manual de instalación Pagina 11