PureFlow AirDog FP-100 Manual de instalación descargar pdf (Pagina 17)

Installation Manual Section 7

PUREFLOW® DIESEL SYSTEM

AirDog™

INITIAL START PROCEDURE

The AirDog™ is a self priming system, however, to prevent damage to a dry seal and

reducing the life expectancy of the system, it is recommended to prefill the water separator

with diesel fuel before initial startup.

7-1 Prefill the water separator with diesel fuel.

7-2 Turn the starter key to the on/run position.

Note: It may be necessary to momentarily engage the starter in order for the ECM to

energize the AirDog™.

7-3 While the AirDog™ is on, bleed the fuel line to the engine by loosening the fuel line

connection at the engine fitting. As soon as the line is purged of air and pure fuel is

observed, properly tighten the fuel fitting. NOTE: put a rag or shop towel over and

around fitting to prevent splatter. Catch all spilled fuel and dispose of properly.

RECHECK ALL FUEL FITTINGS FOR LEAKAGE AND PROPERLY TORQUE. BE

SURE ALL LINES ARE PROPERLY ROUTED TO PROTECT FROM EXCESSIVE

HEAT AND SECURED TO PROTECT FROM CHAFFING AND ABRASION.

RECHECK ALL ELECTRICAL LINES, SECURE AS NECESSARY.

7-4 Start engine!

NOTE: Should any installation problems arise, please call, toll free 1-877-463-4373, for

assistance (Monday – Friday, 8:00 am – 5:00 pm CST).

Visit our website at www.pureflowtechnologies.com for updated materials and frequently

asked questions.

1 2 ... 12 13 14 15 16 17

Sin comentarios

PureFlow AirDog FP-100 Manual de instalación Pagina 17